Matters needing attention when forging

Jiahangaero said that if you want the quality of aluminum forged products to be better, you must meet the following production conditions during the forging process:

• When aluminum alloy products are solidified, the hydrogen content inside should be reasonable. If the content is greater than the solubility, then it may cause bubbles to appear. If these bubbles cannot float up, pores will appear during solidification. , Therefore, the content of hydrogen should be matched according to the requirements.

• In order to proceed smoothly during production, mold selection is very important. When choosing a mold, everyone should pay attention to whether the process parameters are correct, because both process parameters and mold design will directly affect the overall production effect, so , Whether it is choosing a mold or determining the process parameters, you must be careful. Only in this way can the forged castings in the actual production process meet the requirements.

Jiahangaero said that because the strength of forged aluminum alloy products is better than that of other forging methods, its forged parts will be lighter under the same size, and because of this reason it is currently popular in the market. The degree is very high. However, when choosing a casting, it depends on whether it meets the relevant production standards and whether there are some defects. If there are, then such castings must be reworked before they can be put into production. The life of the product as a whole may be shortened.